Help!! what is the proper placement for the fender emblems on the 67 Shelby measurements above the gt stripe and placement as well as the deck lid emblem location measurements thanks, Nick
Re: 1967 shelby GT350 badge spacing Branda sells a manual that is a reprint of the 1967 Shelby engineering drawings which has the specific info in it you need. I'm sure the other info in the manual will be benefical to you as well. Bob
Re: 1967 shelby GT350 badge spacing thanks I have that book has every emblem location and measurment but the fenders, could some one please get a fender measurment above the stripe spacing for me thanks Nick
Re: 1967 shelby GT350 badge spacing Sorry about that I thought the fender emblem measurements were also in that manual . I will take measurements tomorrow if no one else posts.Bob
Re: 1967 shelby GT350 badge spacing Nick, I checked two cars that used the factory installed pin holes and both were 1 3/4 inch from the edge of the stripe to the bottom of the plastic chrome emblem. I am sure there was some slight variance as this was done by the best help money could buy at minimum wage. I hope this helps. Bob
Re: 1967 shelby GT350 badge spacing Nick and Bob, I just went out and checked my 67 GT 350 it also measured 1 3/4 , for added confirmation. Snakeman
