Join Shelby Forums Today

67 shelby heat shield?

Discussion in '1965-1970 Shelby Mustang GT350 & GT500' started by 2dragpac500converts, Jan 2, 2010.

  1. Jan 2, 2010 #1
    2dragpac500converts

    2dragpac500converts Well-Known Member

    Posts:
    174
    Likes Received:
    1
    Joined:
    Nov 22, 2007
    Location:
    missouri
    Did 67 gt350s get that thin heat shield that bolted between the motor mount and the engine block.
     
    2dragpac500converts, Jan 2, 2010
    2dragpac500converts, Jan 2, 2010
    #1
  2. Jan 2, 2010 #2
    Bob Gaines

    Bob Gaines Well-Known Member

    Posts:
    1,146
    Likes Received:
    37
    Joined:
    Jan 7, 2006
    The short answer-no.
     
    Bob Gaines, Jan 2, 2010
    Bob Gaines, Jan 2, 2010
    #2
  3. Jan 3, 2010 #3
    2dragpac500converts

    2dragpac500converts Well-Known Member

    Posts:
    174
    Likes Received:
    1
    Joined:
    Nov 22, 2007
    Location:
    missouri
    Thanks.

    Motor is in. Damn thing sure sits awfully high in the front still. I purchased springs from eaton. I hope they are correct.
     
    2dragpac500converts, Jan 3, 2010
    2dragpac500converts, Jan 3, 2010
    #3
  4. Jan 3, 2010 #4
    Bob Gaines

    Bob Gaines Well-Known Member

    Posts:
    1,146
    Likes Received:
    37
    Joined:
    Jan 7, 2006
    If you check the chassis assembly manual it will give some proper ride height measurements to put you mind at ease . Also I have seen that somtimes the springs need time to settle. After it bounces a number of times the springs may settle some. FYI it is supposed to be a little higher in the front then in the back from the factory. Bob
     
    Bob Gaines, Jan 3, 2010
    Bob Gaines, Jan 3, 2010
    #4

Share This Page