Separate names with a comma.
Most of us who restore originals will usually degrease them, then do a clean up with Eagle One Aluminum wheel cleaner. Make SURE you wash them...
I was curious if anyone was running the Centerforce dual friction in their 428? If so did you encounter any clearance issues with the weights and...
My vehicle just returned from paint and I installed the new trunk lid gasket. The issue is that it doesn't want to latch now, even with the latch...
Bob covered a point I failed to mention. The fuel log is also problematic when it comes to vapor lock. I will see if I can find a picture, but...
As we all know by now, Ford/Shelby simply used a paper gasket. I didn't machine the C7ZX manifold, and yes, these things run hot as hell. I know...
Re: 1967 upper lower scoops should be sealed with what? No clamps on the brake ductin Bob, I was concerned with the RTV getting on the paint...
Rodster: The factory manual calls for GE RTV108 Silicone. It is not water soluble and a down right nasty, sticky and stinky product. As a matter...
I am reassembling my Shelby post return from paint. I noted in the "assembly manual" that Branda offers, that it respectively calls for SA60001...
I am looking for the rubber grommets that are in the rear of some '67 Shelby headlamp buckets and the plastic Panduit wire retainers that were...
The best installation for a new gasket is to unfold it, lay it on the bench, use a heat gun, do not overheat it! It will relax and you can start...
Bob, Thank you for the prompt reply. I have been quite ill and the vehicle was gone for 16 months for paint and shell assembly. Now we'll soon...
