Separate names with a comma.
Thanks ZRay, After getting your post I went out and popped the distributor cap and rotor and found the following. The springs are the light...
The distributor was almost full advance at about 1800 rpm, changed the springs back to 2400, changed carb seats etc, will post exact changes later...
My 67Gt500 recreation has a 66 Thunderbird 428CI in it. Running 67 390GT heads, hardened seats,pocket ported, short turn radius worked mildly,...
Here is a couple photos from an original GT350 Photo file to large, if you need them send me an e mail and I can forward them.
Don't know if you got answer back when you asked, but my parts interchange book shoes C6OE-E AND F AS 18 1/4 inch, seven blade, 2 3/8 center hole...
You can use a dremmel or a hand coping saw I believe is the name of the saw. I used a dremmel, I used masking tape around the area being trimmed...
I bought my Grabber Orange Shelby GT recently and had the occassion to drive it from So. Cal. to Redding and then Redding to Spokane, Wa. over...
My former 67GTA after transforming to its current 67GT500A version
I'm trying to install a roll bar into a 67 Mustang fastback, like the ones used on the Shelby's and after reading this forum I have a couple...
Re: rollbar seatbelts for 67 shelby I was looking for those myself the other day and stumbled across a web site called shelbybelts.com I believe....
