Separate names with a comma.
Got it all figured out. If you haven't had the opportunity to deal Bill Heely at Vintage Ford Shifters, I'll say that he has been a tremendous...
Email sent. Thanks for the help.
Does anyone have a nice picture of the T10 trans installed in the car, or a diagram from a shop manual. The Comet/Fairlane/Mustang manual for...
Sounds like we're using the same gaskets..about .320" thick but I don't recall the part number right off the top of my head. The bolts that were...
AMK's site? Do you have a link? Thanks so much.
I'm hunting some reproduction valve cover bolts for the 66 GT350. Problem is that I need them to be 1" long to account for the thicker valve...
I'm looking for a little help in what to paint in what colors for some of the miscellaneous pieces of a 1966 GT350 engine. Specifically, items...
Thanks Snelly. I found a source for the levers and rods from Ford Vintage Shifters.
On the bottom pad of the toploader? I'll take a look. The toploader crosses to a 1965 Mustang hence I don't believe that it is correct for the...
I'll have to check that out!
Looking at the graph, it looks like it actually richened up on the third pull which is likely the cause of the power/torque change. Without...
Thanks Swede. I located and rebuilt a cast iron/cast iron close ration (H-code) T10 from a car less than 100 S/N away. Talked with a pretty well...
I'm trying to determine the correct transmission and shifter combination for a 1966 Shelby GT350. The car is later in the delivery cycle, S2214...
