Cutting your panels for the 67 roll bar

If its the fastback bar he sells, I would bolt it to the upper roof supports then see were the legs end up on the torque box and weld [should be just after the forward curve area of the torque box]. mark out roughly were the bar will go on your rear panel. I would then start out small and work the area bigger till it fits. Not sure a template would work if its not an original roll bar? [2Cents]

 

If you want,I have a pair of original 67 Shelby panels that I will sell,with the notches already done.Let me know at greatcustoms2@comcast.net.
Greg

 

Welcome aboard and good luck with your customization!