Separate names with a comma.
Define "cheap".
This is not something to mess with. Get four more SCJ rods, make sure you have a set of eight matched pistons, get it all balanced, and you'll be...
That was for shlby66, who mentioned had had one "…a forum member, hand produces a beautiful switch, that is so close to the original, its...
OK, I don't recall the number, but it was late in the year. Does the Shelby registry also report the steel hood?
It's been repainted once, shows evidence of replacement of the RH fender, and some body filler on the rear. The alternator is a rebuild, but has...
So, you gonne ebaY that bad boy as a "replica"?
Shelby? What Shelby? [IMG]
Of course. The first was an example of what it should cost. The second was a cautionary note. It's an excellent reproduction, of a much more...
Funny thing, if you did reproduce the switch, after selling about a dozen, you'd have used up the demand. This switch sells for $6 [IMG]...
It's really a good idea to use a distributor machine, or at least a controlled vacuum, to set the precise curve specified by Ford. This adjustment...
Hmmm… I had the cam follower on one set of points break off one evening, and no tools. Using trash at the side of the road, I was able to open the...
Pretty good guess, considering it sold in the middle of the recession. [IMG]
I would do it stone-stock but blueprinted. A bottle of ZDDP eliminates cam problems. Since we're talking about a real Shelby, IMHO original...
I wouldn't use bronze guides, I'd use cast iron. Much more durable. Other than that, I'd go stock. Unless this Shelby will be your daily commuter...
Sure, the convertible went low, in the middle of a recession. It also suffered from having been largely reconstructed. This is what it looked like...
[IMG]
Re: Heater Cable Adjustment Nahh, this stuff was designed to be installed by auto workers who were in a hurry.
The most likely non-CA FE oil cap has, finally, been reproduced. Not marked "Motorcraft", of course. [IMG]
The piece that holds them is the turn signal switch. You must replace it entirely. The steering wheel needs to be removed, but not the column. You...
Yes, it's a handy spot, using the screw that's already there.
yep.
I'm just thinking out of the box, since the guy is turning a 67 Mustang into a 68 GT/CS clone, I figure there's really no point on going "stock"....
Several sources make the Shelby/GT/CS taillight wiring harness, and all you need to make it work. One other possibility is what this car is fitted...
Assuming you have a 68, the oil gauge wire came out the firewall, along the intake manifold, to where the oil light wire branched out of the...
More recently I had this problem, and the above tricks just didn't cut it. I removed the LH valve cover, padded the engine and master cylinder,...
