Separate names with a comma.
Are these available at the local auto parts (Advance, Auto Zone, etc)?
A friend of mine is very high on Royal Purple products and uses them exclusively on his newer GM vehicle. He thinks I should use them also on my...
Any recommendation for gaskets and gasket sealer? Along time ago Permatex (?) was used but I thought maybe something better has hit the market....
Re: Opinion Please Good advice, thanks!
Z. Ray, It is hooked up and works perfectly. When I got home tonight I traced the end of the black wire and it plugged into a red wire. Using...
Joe, Thanks for the advice, it sounds very doable and I will let you know how it turns out (probably in about 3 weeks). Ron
I think I did the same thing on my old 1966 Mustang GT, I just thought maybe there was a better way short of pulling the engine. Ron
Re: Opinion Please Good advice, I just ordered a new idler arm and pitman arm from Branda today to take with me just in case one of them is...
Thanks for the link, I did find an "original type 1966 Shelby Tachometer wiring diagram" on Tony Branda, it shows 4 wires out of the tach, a green...
Z. Ray, Thanks for the information, I do have the instructions but could not figure out which wire to tap the red wire (from the tach adapter)...
Is it very hard to pull the oil pan with the engine still in the car? I need to replace my oil pan gaskets and just wonder if it is possible and...
Re: Opinion Please Steve, Will do, I plan on going to Cotton Brothers, they worked on my 1966 Mustang GT many years ago and did a great...
Another question this time on the tach. The previous owner added the MSD 6AL system, this system removed one of the dual points and added an...
Re: Opinion Please Again thanks for all the good advise. The tires currently are 205-70 14's not an overly large tire I would not think. The...
Re: Opinion Please Thanks for the great advise. I will have the unit rebuild, sounds like the best way to go. I will go over the front end and...
On my 1966 GT350 clone the steering is very hard to turn and the car wanders at highway speed, I think it is the steering gear and plan on...
That may be the problem, when the valve cover was modified the PCV was pulling a lot of oil into the engine so the owner removed the PCV and put a...
I just bought a 1966 GT350 (clone), it has an original 'K' code engine from a 1966 Shelby that was rebuilt a few years ago, bored 0.040 over with...
Thanks for the good advise, I will check it out.
Possible, but the car looks very correct.
Thanks again, I will check with them, you never know.
Thanks for reply. The area that needs work do you think anyone has the paint in rattle cans?
Hi, I am new to the forum and just purchased a 1966 GT350 clone, it looks very good but I need to have part of the Lemans stripe repainted, does...
