Separate names with a comma.
Thanks for the replies. I buy from West Coast Classic Cougar often but they couldn't help on the compressor. I'll try Classic Auto Air...
I'm working on a '69 that's about 80% assembled after partial restoration. Most of the interior is out and I'll have (at least) part of the dash...
If it's any help the car I'm working on is 6/69 and the brackets are welded Cheers DD
On the car I have the black/green wire goes to the o/p gauge. if you were holding the o/p gauge in your hand, looking at the backside, with the...
It so happens the the '69 I'm working on has the console partially removed so maybe this will help..... Under the ashtray is a 2-pin connector...
Resurecting an old thread. I've been waylayed and still haven't finished this aspect of the project. A couple more questions.... 1) Is it...
Ahhhhhhhh. OK. Suddenly it all makes sense. The wires that somebody (not me!) ran to the core support are supposed to go to the lamp mounting...
More info..... You guys probably know all about this but I thought it I'd throw it open for comment. I had an opportunity to compare this...
Ok, thanks for the reply and confirmation that I wasn't losing my marbles. If nobody posts a pic I'll work up a nice sanitary ground. Cheers DD
I'm stumped. Got all the exterior lights working perfectly...even the rear sequential signals.... except the front park/signal lamps. The...
100 Thanks, guys :evo: Cheers DD
Bit by bit I'm getting this car assembled...always a challenge when someone else has disassembled it....heh heh Anyhow, take a peek at the pic....
Bob, thanks for your help on this question and the tail light cover one as well. Cheers DD
My understanding is that the Faria oil pressure gauge used a standard issue FoMoCo sending unit. If that's correct, is there any particular...
1969 GT500 Convert Memory refresher, please. It's hell getting old. Are the carboard panels that protect the tail lights and tail light...
Ahhhhh! Got it ! I know exactly what you're talkin' about. I just didn't put two-and-two together! 100 thanks, Bob Cheers DD
Hi everyone, been a long time since I posted. I'm back on the '69 Shelby Convertible...trying to piece it together. The [what I believe to be]...
Thanks for the reply. Hey, I was born in Elgin...53 years ago today! :) From further research and replies elsewhere I'm pretty well convinced...
Can someone tell me if the following assumption is correct? The '69 swing-away vacuum system has two variations. One type uses a single port...
Thanks again for the help. I think I've got a bit of a research project ahead of me. If I come up with anything conclusive I'll post back....
Many thanks, Dan. I've attached a pic of what I have goin' on. Notice the shiny witness mark on each spinner. Although the taper of the...
Hi everyone. I trying to figure out a little mystery on an '67 AC Cobra 427. I'll try to be brief. The car has (what I believe to be) original...
Heh heh. Unless there's a consistant trend showing similar complaints I take internet-aired consumer disputes with a grain of salt. Too much...
OK, Pony Carbs sounds good to me. Many thanks, DD
Hi everyone :-) If anyone can recommend a reputable carb restoration service, I'd be grateful. There seem to be plenty of specialists out...
