I am wanting to customize my shelby charger,and was wondering if anyone nows of a frame from another car that would fit under it to hold a v8, i have did research, and an 80's v8 mustang is only a few inches wider then my shelby charger. if any one has any suggestions i would be appreciative. and please dont reply with hate mail or hate-replies, cause it is immature, this is an honest question. thank you
so will the 80's gt sub-frame work with some fab work done to them? or would it be just as hard to make a full chassis? i have made chassis's before with my father. ( both were full 2 x 3, on a vega, and second was a vega gt.) i do want to get into a little racing, so ill prolly just go with making a chassis. but any info u could shed would be nice. like a v8 rear-end that will fit decent, i do know the mustang gt's around 84 have a body width of around 3 inch's wider then my shelby.
I think direct connection used to make a kit for this type of swap. I remember seeing a couple done back in the nineties.
